- Safety Procedures Sync in Gas Exposure
- Lessons Learned from ICS Attack
- Fukushima Radiation at Fatal Levels
- Ukrainian Man Sentenced in Hacking Case
- Hard Time for Hacking into GA Pacific
- Safety Systems Worked in CA Refinery Blast
- Connected Car: Start Thinking Security
- Rockwell Fixes Parser Buffer Overflow
Chemical Safety Incidents
Device to Boost Solar Panel Power Output
Wednesday, June 22, 2016 @ 03:06 PM gHale
As advancements in solar cell technologies significantly improved sunlight-to-energy conversion efficiencies, without continued advancements in panel technology, photovoltaic (PV) systems will never realize their maximum potential.
This is because technological limitations prevent solar panels – which amplify and boost the electric current generated by multiple solar cells – from supplying all the electricity they generate to the electric grid.
That may soon change as a team of researchers from the Masdar Institute in Abu Dhabi may have discovered a way to overcome these technological limitations in the most popular PV connection system through a novel, low-cost and easy-to-install device that could significantly increase the amount of power generated by the system.
“The problem occurs in series-connected solar panels (which is one of the most common ways of connecting solar panels for distributed PV systems), when solar modules are experiencing varying levels of irradiation or temperature. This can result from sporadic clouds, dust accumulation on the PV panels, or uneven air ventilation. In these instances, the current generated by each module is different,” said Masdar Institute Research Engineer Omair Khan.
“The low-performing solar modules affect the energy output of the entire string of solar panels, as the maximum power output is governed by the lowest current in the system. This means that if one solar module is shaded and thus generating a low current, and is connected in series to several good, high-performing modules, then the high-performing modules cannot operate at higher currents,” he added.
The device developed by Khan and Masdar Institute Associate Professor of Electrical Engineering and Computer Science Dr. Weidong Xiao aims to optimize the power output of the series-connected solar panels.
Series-connection is how the majority of PV panels end up connected in a PV system and to electrical grids, including small-scale rooftop PVs and large-scale solar power plants.
Series-connected solar panels direct the electrical currents produced by each submodule (usually three submodules form a solar panel) through the group, or “string,” of connected solar panels to the string’s centralized converter. The drawback of series-connected solar panels is that each panel needs to share the same electric current, which is set by the submodule with the lowest current.
Khan and Dr. Xiao discovered a way to get around this “lowest current” limitation that series-connected solar panels face, through their device – called a “submodule integrated converter” – which tracks and feeds each of the three independently produced electrical currents for one solar module directly into the centralized converter, thus boosting the PV system’s overall power output, especially in the case of a current mismatch.
It does this by capitalizing on the key properties of gallium nitride, which is the material used to make the converter’s switches. Gallium nitride’s high electrical conductivity is able to convert 99 percent of the power produced by each submodule into electricity for the centralized converter and enables the device to be made small enough to fit into the existing junction box on the back of each solar panel. Thus, the device can easily install into existing solar panels without needing to retrofit or re-build conventional solar panel systems.
“By employing a dedicated converter to independently perform maximum power point tracking on each submodule, rather than the string of modules as a whole, means that the operating point of each submodule has no effect on the rest of the submodules in the system. Each converter extracts the maximum power possible from each submodule, thus maximizing the PV system’s energy-efficiency,” Khan said.
“Through this novel device, we are able to get more electricity out of conventional solar panels using a method that is easily scalable,” Dr. Xiao said.
The researchers plan to optimize the product and develop a ready-to-install version capable of withstanding the UAE’s harsh weather.