North Sea Gas Leak Stopped

Wednesday, May 16, 2012 @ 09:05 AM gHale


Total’s North Sea Elgin platform gas leak stopped, after leaking gas for more than seven weeks, the French oil group said today.

Teams of experts from Total and specialist contractors will closely monitor the well, located 240 km off the coast of Scotland, in the coming days to confirm the success of the operation. As a part of the “well kill” process, Total pumped heavy mud into the well to suppress the gas flow and it lasted 12 hours, Total said on its website.

RELATED STORIES
Total ‘Well Kill’ Begins
Total Diverts North Sea Gas Leak
Total: Leak Could End This Month
North Sea Flare Out; Gas Leaking

If proved effective Total would no longer need to drill relief wells as an alternative measure. Drilling of one of two planned relief wells began last month.

“Today, a major turning point has been achieved,” said Yves-Louis Darricarrere, Total’s head of exploration and production.

A company spokesman said it was too soon to say when gas and condensate production could resume. The well that was the source of the gas leak was no longer in operation.

The Elgin platform, pumping some 3 percent of Britain’s gas output from nearly four miles below the seabed, is one of the deepest, most highly pressurized gas fields in the world.

Output was 9 million cubic meters of gas per day (mcm/d) and 60,000 barrels per day (bpd) of light oil, according to Total.

The leak has been costing Total around $3 million a day in relief operations and lost net income.

Total has suffered several production setbacks. On top of Elgin, safety issues in Yemen and a gas leak in Nigeria are putting a damper on its ability to meet its annual average production target of 2.5 percent growth through 2015 at $100 a barrel of oil.

Total’s chief executive Christophe de Margerie has said the Elgin leak would cost the company slightly more than $300 million in lost production in a worst case scenario where production did not restart before the end of the year.



Leave a Reply

You must be logged in to post a comment.