Sensor Imperfections Work Better

Tuesday, November 29, 2011 @ 12:11 PM gHale

Graphene does make a very good chemical sensor, but the sensors’ performance improves even more when the material has more imperfections. Go figure.

“This is quite the opposite of what you would want for transistors, for example,” said Eric Pop, an assistant professor of electrical and computer engineering at the University of Illinois and a member of the interdisciplinary research team. “Finding that the less perfect they were, the better they worked, was counter intuitive at first.”

Foamy Sensor Detects Explosives
Language can Identify Security Vulnerabilities
Detecting Threats Before they Happen
Shoe Sampling for Safety

The research group includes researchers from chemical engineering and electrical engineering, and from a startup company, Dioxide Materials.

“The objective of this work was to understand what limits the sensitivity of simple, two-terminal graphene chemiresistors, and to study this in the context of inexpensive devices easily manufactured by chemical vapor deposition (CVD),” said Amin Salehi-Khojin and David Estrada, lead authors of a paper on the subject.

The researchers found the response of graphene chemiresistors depends on the types and geometry of their defects.

“Nearly-pristine graphene chemiresistors are less sensitive to analyte molecules because adsorbates bind to point defects, which have low resistance pathways around them,” said Salehi-Khojin, a research scientist at Dioxide Materials and post-doctoral research associate in the Department of Chemical and Biomolecular Engineering (ChemE) at Illinois. “As a result, adsorption at point defects only has a small effect on the overall resistance of the device. On the other hand, micrometer-sized line defects or continuous lines of point defects are different because no easy conduction paths exist around such defects, so the resistance change after adsorption is significant.”

“This can lead to better and cheaper gas sensors for a variety of applications such as energy, homeland security and medical diagnostics” said Estrada who is a doctoral candidate in the Department of Electrical and Computer Engineering.

The two-dimensional nature of defective, CVD-grown graphene chemiresistors causes them to behave differently than carbon nanotube chemiresistors, the authors said. This sensitivity is further improved by cutting the graphene into ribbons of width comparable to the line defect dimensions, or micrometers in this study.

“What we determined is that the gases we were sensing tend to bind to the defects,” Pop said. “Surface defects in graphene are either point-, wrinkle-, or line-like. We found that the points do not matter very much and the lines are most likely where the sensing happens.”

“The graphene ribbons with line defects appear to offer superior performance as graphene sensors,” said ChemE professor emeritus and Dioxide Materials Chief Executive Richard Masel. “Going forward, we think we may be able engineer the line defects to maximize the material’s sensitivity. This novel approach should allow us to produce inexpensive and sensitive chemical sensors with the performance better than that of carbon nanotube sensors.”

Leave a Reply

You must be logged in to post a comment.