Steel Maker Fined for ‘Avoidable’ Hazards

Monday, May 11, 2015 @ 12:05 PM gHale


An electric technician at the Republic Steel Corp. steel manufacturing plant in Blasdell, NY, was removing wiring from a fan motor in an overhead crane October 16, 2014, when an ungrounded electrical conductor touched a grounded surface causing an arc flash, said officials at the Occupational Safety and Health Administration (OSHA).

As a result, the technician sustained third degree burns on her hand and first degree burns on her face.

RELATED STORIES
Safety Fines for IL Dryer Maker
Amputation Leads to Safety Fines
Hazardous Gas Fines for Energy Firm
Chemical, Fire Hazards at Soap Maker: OSHA

After an OSHA investigation by the Buffalo Area Office, investigators found Republic Steel failed to provide and ensure the use of effective face and hand protection by its employees.

As a result of these conditions, OSHA cited Republic Steel for two repeat violations, with proposed penalties of $70,000 each for the lack of hand and face protection. The steel manufacturer also received one serious violation, with a $7,000 fine, for failing to protect employees against contact with energized electrical equipment. Total proposed penalties are $147,000.

Republic Steel contested its citations and proposed penalties to the independent Occupational Safety and Health Review Commission.

“These injuries were avoidable. Republic Steel has a responsibility to make sure that its electric technicians are properly trained, equipped with and using personal protective equipment to protect from arc flash,” said Michael Scime, OSHA’s area director in Buffalo. “In this case, that would include a face shield and rubber insulating gloves. The company should be especially aware of this, since OSHA cited Republic Steel earlier in 2014 for similar hazards at its Lorain, Ohio, facility.”



Leave a Reply

You must be logged in to post a comment.