Cisco fixed a vulnerability in the enhanced Preboot eXecution Environment (PXE) boot loader for Cisco IOS XR 64-bit Software that could allow an unauthenticated, remote attacker to execute unsigned code during the PXE boot process on an affected device.

The PXE boot loader is part of the BIOS and runs over the management interface of hardware platforms running Cisco IOS XR Software only.

The vulnerability (CVE-2020-3284), which Cisco rated as high and has a CVSS base score of 8.1, exists because internal commands issued when the PXE network boot process is loading a software image is not properly verified. An attacker could exploit this vulnerability by compromising the PXE boot server and replacing a valid software image with a malicious one.

Alternatively, the attacker could impersonate the PXE boot server and send a PXE boot reply with a malicious file. A successful exploit could allow the attacker to execute unsigned code on the affected device.

To fix this vulnerability, the Cisco IOS XR Software and the BIOS must end up upgraded. The BIOS code is in Cisco IOS XR Software but might require additional installation steps.

Schneider Bold

Cisco software has updates that address this vulnerability. There are no workarounds that address this vulnerability.

This vulnerability affects Cisco devices if they are running a vulnerable release of Cisco IOS XR 64-bit Software and if they meet the following conditions:

  • The product ID (PID) of the device matches one of the PIDs listed here 
  • The device is running a vulnerable BIOS version
  • The device uses PXE for network boot

PXE is included in the network card of the management interface of routers running Cisco IOS XR Software and is part of the device BIOS. PXE ends up used to re-image the system and boot the router in case of boot failure or in the absence of a valid, bootable partition. PXE acts as a bootloader and provides the flexibility to choose the image the system will boot based on the PID, the serial number, or the management interface MAC address. PXE downloads an ISO image, which ends up specified as part of the PXE reply from a PXE boot server, installs the ISO contents onto the device, and then transfers control to the installed software image.

PXE must end up defined in the DHCP server configuration file.

In addition to this issue, there are 12 vulnerabilities from Cisco rated high.

Pin It on Pinterest

Share This