Cisco has a fix available to handle a high-rated vulnerability in the software-based SSL/TLS message handler of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software that could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS).

This was just one of Cisco’s 17 vulnerabilities released this week, of which 9 ended up rated high and 8 rated medium. This is part of the October release of the Cisco ASA, FTD, and FMC security advisories.

This vulnerability is due to insufficient validation of SSL/TLS messages when the device performs software-based SSL/TLS decryption.

An attacker could exploit this vulnerability by sending a crafted SSL/TLS message to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.

CVE-2021-34783 is the case number for the vulnerability, which has a CVSS base score of 8.6.

Schneider Bold

Datagram TLS (DTLS) messages cannot be used to exploit this vulnerability, Cisco said in its advisory. Cisco released software updates that address this vulnerability. There are no workarounds.

This vulnerability affects Cisco devices if they are running the following Cisco software releases under the following conditions:

  • ASA Software, versions 9.16.1 and 9.16.1.28, if affected devices are configured to process inbound SSL/TLS message, they are vulnerable to crafted SSL/TLS message sent to the device
  • FTD Software, versions 7.0.0 and 7.0.01, if affected devices are configured to process inbound SSL/TLS message, they are vulnerable to crafted SSL/TLS message sent to the device
  • FTD Software, versions 6.3.0 and later, but earlier than the first fixed release, if affected devices are configured with an active SSL Decryption Policy, they are vulnerable to crafted SSL/TLS message that are sent through the device

To verify whether a device that is running Cisco ASA Software or Cisco FTD Software could process inbound SSL or TLS messages, use the show asp table socket | include SSL command and verify it returns output. When this command returns any output, the device is vulnerable. When this command returns empty output, the device is not affected by the vulnerability described in this advisory.

There are two methods for determining whether an SSL decryption policy is enabled:

  1. Use the show ssl-policy-config CLI command to verify whether an SSL decryption policy is enabled on a device.
    Any other output returned by the show ssl-policy-config command indicates an SSL policy is configured and the device is affected by the vulnerability described in this advisory.
  2. Another option to determine whether an SSL decryption policy is enabled on a device, check the appropriate policy:
    — For devices managed by Firepower Management Center (FMC): Policies > Access Control > SSL
    — For devices managed by Firepower Device Manager (FDM): Policies > SSL Decryption

Click here for the complete list of advisories.

Pin It on Pinterest

Share This