Whether it is personnel misjudging grating integrity and/or not understanding how physical changes to the grating affect integrity, there has been an increase in safety incidents.

From 2020 to 2021, there were multiple grating failure incidents reported to the Bureau of Safety and Environmental Enforcement (BSEE), including:

  • A fatality occurred when grating gave way on a platform in the Gulf of Mexico as personnel stood on grating after it had been ripped and chisel gunned.
  • A man overboard incident occurred when grating shifted as personnel walked on the grating after the welds holding the grating to the structure were removed.
  • A near-miss incident occurred when a worker walked over severely deteriorated grating, but caught himself before falling completely through.

When replacing grating, demolition operations such as ripping grating (cutting the crossbars along a sheet), needle or chisel gunning, and removing anchor welds can affect a section of grating’s ability to hold personnel or equipment. The ability of deteriorated grating to hold weight cannot be determined visually or by prior experience, especially after demolition operations have begun.

To that end, BSEE recommends operators and contractors consider the following:

Schneider Bold

Train personnel on the dangers of insufficient grating.
— Physical alterations to grating such as ripping, needle or chisel gunning, and/or removing anchor welds or clips will decrease the load capacity possibly causing grating that held persons before these actions to become unsafe.
— When replacing deteriorated grating, personnel should assume the grating to be unsafe to walk on without fall protection: The integrity of deteriorated grating cannot be judged visually, and Walking on deteriorated grating previously without incident does not ensure an incident will not occur.
— Modifications to a sheet of grating can affect the rated load capacity.

Create or revise procedures for the removal and replacement of grating to ensure removal preparations do not create a more hazardous walking and working surface, specifically for work on large areas or entire decks.
— Procedures should provide orderly steps conducive to working on small areas of affected grating at a time and identify safe working practices.

A fatality occurred when grating gave way (bottom photo) as personnel stood on it after it had been ripped (top photo) and chisel gunned.Source: BSEE

Practice preventative maintenance rather than reactive maintenance where possible. Replace grating before it is deemed hazardous.

Review Safety Alert 427 for recommendations regarding fall protection and barricading practices during grating replacement operations.

Pin It on Pinterest

Share This