When a safety incident occurs on an offshore platform, whether it is a big incident or a small one, it needs careful consideration.

Consider one incident where a worker observed an arc flash while performing construction activities that required additional lighting in the work area. As a result , construction personnel ran an extension cord from a welding machine to portable lights needed in a different location, but when the machine was turned on, the electrical welding lead cable arced and glowed, according to a report with the Bureau of Safety and Environmental Enforcement (BSEE).

A nearby worker immediately pulled the lead cable away from a self-retracting lanyard (SRL) cable, breaking the SRL cable. In the incident, no fire occurred and no personnel ended up injured.

Upon immediate investigation, personnel discovered the rubber protective coating on the electrical welding lead cable was worn down by the continuous movement of steel SRL cable rubbing against it, which resulted in exposed welding lead cable wires.

When the welding machine turned on, the steel cable on the SRL made metal-to-metal contact with the welding lead cable wires and triggered the arc flash. This caused damage to the welding lead cable and SRL cable.

Schneider Bold
  • As a result of the incident, BSEE recommended operators and contractors consider the following:
  • Confirm proper separation of electrical energy sources, such as electrical cords and welding leads, from rigging, fall arrest equipment or any other identified equipment on a work site that could cause physical damage
  • Ensure welding leads and SRL cables end up separated during hot work activities and avoid putting them through the same deck penetration plate
  • Inspect welding leads and SRL cable before use to ensure they are in good working condition
  • Ensure safe routing of electrical equipment cords, cables, etc., to prevent abrasion and abnormal wear of their protective sheathes/coatings
  • Before work begins, check the final worksite to ensure all safety provisions/systems are in place and all hazards are controlled and risks are reduced to as low as reasonably possible
  • Ensure all permit to work and job safety analysis documents and reviews include inspection and assessment of the electrical hazards prior to the start of a job

A frayed SRL cable that made contact with metal grading.
Source: BSEE

Pin It on Pinterest

Share This