The result of the incident caused damage to a section of the lubricator, said officials at the Bureau of Safety and Environmental Enforcement (BSEE).
The incident investigation found the cotter pin at the end of the hook pin had sheared, which allowed the washer to fall and the pin to back out. When the pin backed out, it caused the ear on the connection to distort, resulting in the hook failing.
The investigation also found there was an inadequate pin configuration design. As it turns out the pin installed on the hook assembly had a smooth composition. In fact, the operator determined a threaded bolt with nuts and keepers was the proper pin design for ensuring the stinger remains secure throughout lifting operations.
Following this event, the operator inspected their other facilities and found the same improper arrangement on additional cranes.
As a result of the incident, BSEE recommends operators and contractors do the following:
- Inspect all cranes on the facility and verify the hook assembly has a threaded pin with nuts and keepers
- Retro-fit any stingers equipped with an improper stinger hook pin configuration
- Verify all crane components are in alignment with current manufacturer recommendations
- Add “assessment of the pin condition” into the pre-use inspection checklist, which should be completed before conducting lifting operations


