The injured worker and his assistant deviated from the planned scope of work, failed to rig up the mid-section to the bridle prior to removing the mid-section to boom tip connector pins, and then failed to use boom connector safety pins, according to a report with the Bureau of Safety and Environmental Enforcement (BSEE).
After removing the bottom right pin, both employees assumed the bottom left pin would be difficult to remove since it was bearing the weight of the boom section. When the worker struck the remaining connector pin, it unexpectedly ejected, causing the boom to drop and pinning the lead mechanic’s leg against a sledgehammer and grating, and fracturing his tibia.
The response of the facility personnel was critical in providing the injured worker lifesaving interventions until they could get the injured worker treatment at the hospital on shore.
The company’s incident investigation found the root causes were:
- The Job Safety Analysis (JSA) was completed by one employee and did not include rigging up the mid-section to the bridle prior to removing pins or the use of safety boom connector pins. In addition, the injured worker ended up signing off on the JSA without reviewing it.
- There was no requirement for onshore management or the crew to review the JSA before commencing work.
As a result of the incident, BSEE recommends operators and contractors consider the following:
-
- As a result of the incident, BSEE recommends operators and contractors consider the following:
- Review their Safety and Environmental Management System (SEMS) policies and procedures and ensuring compliance with the JSA requirements.
- Reinforce the use of Stop Work Authority (SWA) when the scope of work changes.
- Ensure employees understand the importance of staying out of the line of fire when working near heavy equipment and consider all pinch points when walking down the job.
- Verify all safety equipment is available and in place prior to the job start.
- Provide specific written procedures to individuals disassembling cranes.
- Re-emphasize all individuals involved in a task should thoroughly review the JSA to verify all potential hazards have been addressed, including immediately before the job begins (e.g., during a toolbox talk).
- Ensure specialized contractors create and maintain written procedures and checklists for common jobs that can be referenced during the JSA/hazard analysis process.
- Conduct drills based on realistic injury and first-aid scenarios and inspect medical supplies and kits at the facility level.


