When they got to the location, the operator pulled the relay on the local panel to prevent a restart of the compressor, according to a report from the Bureau of Safety and Environmental Enforcement (BSEE). A mechanic then opened the access hatch and climbed inside the unit while the cooling fan was turning and slowing down. The mechanic then placed his hand on the cooling fan belt and was lifted off the unit floor and pulled into a sheave.
That was an incident that could have been avoided if they had just followed some simple rules.
While this incident occurred on a platform, it could have occurred in any other industrial environement, so to help in the future, the BSEE recommends operators and contractors consider the following:
- Do not enter or access rotating equipment that is still in rotation. Appropriate signage should always be posted to warn of no entry during operation.
- Review job safety analysis (JSA) and Lockout/Tagout (LO/TO) requirements for working on emergency situations and after-hours call-out work.
- Develop safe work policies and procedures in consultation with workers, and provide workers with the necessary information, training, and supervision. Require workers to follow the developed routine and non-routine safe work practices.
- All work should be conducted by fully trained, mentored, and experienced personnel.
- Consider hand safety as a line item on JSA when work involves rotating equipment or other high hand injury potential.
- Refresh the Stop Work Authority (SWA) practices as it applies to after-hours call- out work for employees that would normally be off tour or asleep.
- Review Permits to Work requirements for employees responding to after-hours call-out work. Re-emphasize the need to follow all protocols for JSAs, Safe Work Practices, LO/TO and SWA.


