Cisco fixed a high-rated vulnerability in the implementation of the IPv4 Virtual Fragmentation Reassembly (VFR) feature of IOS XE Software that could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.

This vulnerability is because of improper reassembly of large packets that occurs when VFR is enabled on either a tunnel interface or on a physical interface that is configured with a maximum transmission unit (MTU) greater than 4,615 bytes.

An attacker could exploit this vulnerability by sending fragmented packets through a VFR-enabled interface on an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

Cisco released software updates that address this vulnerability, according to an advisory. There are no workarounds that address this vulnerability.

This is part of the March release of the Cisco IOS and IOS XE Software Security Advisory Bundled Publication.

Schneider Bold

This issue affects the following Cisco products if they are running a vulnerable release of Cisco IOS XE Software and have the VFR feature enabled:

  • 1000 Series Integrated Services Routers
  • 4000 Series Integrated Services Routers
  • Catalyst 8000V Edge Software Routers
  • Catalyst 8200 Series Edge Platforms
  • Catalyst 8300 Series Edge Platforms
  • Catalyst 8500L Series Edge Platforms
  • Cloud Services Router 1000V Series

To determine whether a device is configured for a non-default MTU, use the show running-config | include interface | mtu CLI command. If the MTU has been changed, this command will return mtu under the enabled interfaces.

To determine whether the VFR feature is enabled, use the show ip virtual-reassembly CLI command.

VFR is automatically enabled by features such as Network Address Translation (NAT), Zone-Based Firewall, and IPSec to process Layer 4 or Layer 7 information. Disabling VFR is not recommended. The configuration command ip virtual-reassembly will not be displayed in the output of show running-config unless the VFR feature was manually enabled.

The following are other high-rated vulnerabilities to view where users can apply the necessary updates:

Click here for other security updates from Cisco.

Pin It on Pinterest

Share This