While cutting a section of 12-inch pipe using a five-foot cutting torch, a flash fire struck the contractor on the right side of his face, according to a report from the Bureau of Safety and Environmental Enforcement (BSEE). Fire watch personnel quickly extinguished the fire, and they rushed the contractor to shore to treat his burns.
Hot work includes all work operations that make use of or create sources of ignition. Examples of sources of ignition include welding, hot tapping of pipes and tanks, use of open flame(s), use of cutting torches and grinding, electric heat guns, sandblasting, electrical hand tools, megger testing, soldering, flash cameras, nail guns and other non-explosion proof electrical equipment.
However, releasing the salt water did not eliminate the trapped hydrocarbons from the pipe. The first cut was made on the lower end of the pipe without incident, suggesting the line did not contain flammable vapors or liquids. When the contractor made the second cut on the upper end of the pipe, the gas ignited, causing the flash fire.
Contributing factors for the incident included the following:
- Insufficient identification of hazards: The Job Safety Analysis (JSA) covered the pipe- cutting operation and several other decommissioning activities. It addressed common hazards for this job but only briefly mentioned testing for flammable gas.
- Inadequate work planning: A detailed work procedure specific to cutting and removing piping was not developed, and the entire decommissioning project did not have a work plan.
- Deficient work-permitting system: There was no isolation verification (e.g., mechanical barrier) nor pre-job validation the pipe contained no flammable gas; the pipe was presumed safe and ready for demolition.
- Insufficient policies and procedures: The hot work permit and JSA were unclear about gas detection requirements for the Lower Explosive Limit (LEL).

Contractor employee conducting hot work. During a second cut in a pipe, a worker suffered burns from a flash fire.
Source: BSEE
As a result of the incident, BSEE recommends operators and contractors do the following:
- Always assume all piping and vessels that previously contained flammable liquids or vapors may still contain these flammable gasses until it has been positively verified they are no longer hazardous. Piping or vessels isolated from potential hydrocarbon sources using only a single barrier (e.g., a closed ball valve) should also be assumed to contain flammable hydrocarbons.
- Understand gravity draining a vessel or pipe and opening them to the atmosphere may not be sufficient to remove all flammable liquids and vapors.
- Plan and conduct multi-disciplinary pre-job risk assessment.
- Develop job-specific procedures for:
–Determining no hydrocarbons are present inside vessels or piping before cutting or breaking containment
–Removing hydrocarbons if they are present
— Ensuring hydrocarbons will not enter piping or vessels during the job (e.g., closing and locking valves, installing pipe plugs, etc.) - Develop and follow hot work policy/procedures for tasks involving special hazards (e.g., welding, flame cutting, removing barriers separating hydrocarbons from work areas (breaking containment), working at heights, working in confined spaces, etc.).
- Ensure all contractors use proper work permits and comply with requirements.
- Ensure all operations and contract personnel attend and participate in a pre-job JSA meeting to evaluate the specific job tasks, hazards, and necessary control measures for all hot work and ensure the supervisors of all phases of the work know and understand the complete job scope.
- Ensure all operations and contract personnel involved in hot work attend and participate in a pre-job meeting/toolbox talk. All workers should review the JSA and should ensure all hazards are acknowledged, and policies/procedures, guidelines, contingencies, and communications are understood. Verify the gas detector’s audible alarms will be heard in the work area and individuals know how to respond to the alarm.
- Consider splitting larger jobs with multiple tasks into organized respective units via JSAs and work permits.
- Ensure operator, contractor, and service company employees recognize and understand inadequate communication is one of the most common causes of major accidents, especially when performing hot work.
- Always ensure all individuals involved in the task wear proper Personal Protective Equipment (PPE).

