Graphics Designer of SIMATIC WinCC before V8.2 contains an implicit active content execution vulnerability, which Siemens self-reported, upon opening files, which could allow an attacker to cause arbitrary code execution on the device.
SIMATIC WinCC V7.5 is a scalable HMI and SCADA software system that runs on Windows and Windows Server to monitor and control industrial processes.
The following versions of Siemens SIMATIC WinCC are affected:
- SIMATIC WinCC V7.5 all versions
- SIMATIC WinCC V8.0 all versions
- SIMATIC WinCC V8.1 all versions
In the vulnerability, affected devices implicitly execute active content when opening files. This could allow an attacker to make the user execute arbitrary code on the device.
CVE-2026-59082 is the case number for the vulnerability, which has a CVSS V3 base score of 7.8.
The product sees use mainly in the critical manufacturing sector, and on a global basis.
No Fix Yet
In terms of mitigations, there is no fix available right now.
However, Siemens did say the affected product may end up operated only by personnel qualified for the specific task in accordance with the relevant documentation, in particular its warning notices and safety instructions. Qualified personnel are those who, based on their training and experience, are capable of identifying risks and avoiding potential hazards when working with the affected product. Also make sure to only open files from trusted sources.
As a general security measure, Siemens recommends to protect network access to devices with appropriate mechanisms. In order to operate the devices in a protected IT environment, Siemens recommends to configure the environment according to Siemens’ operational guidelines for Industrial Security.
Click here for additional information on Industrial Security by Siemens.

