One of the most distressing safety incidents seemed to occur way too often last year on oil platforms in the ocean and that was numerous grating incidents.

What usually occurs in these incidents is individuals either partially or entirely falling through the grating, said officials at the Bureau of Safety and Environmental Enforcement (BSEE).

These incidents were primarily associated with repairing or replacing deteriorated grating. Incident commonalities included personnel not donning fall protection equipment and lack of barricades around questionable grating areas.

Because of the increase in occurrences in the Gulf of Mexico, BSEE concentrated on the relevant hazards to identify improvement opportunities. Below are the descriptions of sampled events:

Incident 1: A construction contractor fell into the water while replacing corroded grating on the plus 10 deck.

Schneider Bold

The individual self-rescued by swimming to the nearby boat landing and climbing out of the water. Before falling into the water, the individual exited the barricaded area, removed his fall protection, re-entered the barricaded area without fall protection, and began taking measurements before the suspected grating gave way.

Although the construction crew reported the incident to their immediate supervisor, the “man overboard” incident was not immediately reported to the facility’s person in charge. Photographs of the deteriorated grating and open hole were not captured.

Incident 2: A construction crew member’s foot fell through grating when walking across an area known to have deteriorated and hazardous grating.

The hazardous and deteriorated grating was not barricaded or flagged off (see left photos above), and the individual was not wearing any fall arrest equipment. The individual was able to grab a nearby skid panel during the fall and prevented himself from completely falling through the grating.

Photo of unbarricaded deteriorated metal grating deck, top, and on bottom close up of grating that parted.Source: BSEE

As a result of these incidents and more, the BSEE recommends operators and contractors consider the following:

  • Ensuring all personnel inspect fall protection equipment before donning it and starting work in a barricaded area and/or an area with signage indicating the presence of holes or deteriorated grated and handrails.
  • Ensuring personnel write up a Job Safety Analysis (JSA) (or similar job safety work plan) that covers the fall protection equipment, barricading the area in question, and breaking down how to safely work when repairing/replacing deteriorated or missing grating and handrails.
  • Installing barricades or flagging areas around hazardous, deteriorated, or questionable grating even if there are no open holes present at the time.
  • Having personnel wear proper fall arrest equipment when working in or near any area known to have or suspected to have degraded grating even if there aren’t any open holes.
  • Having personnel stay vigilant of surroundings and hazards while replacing grating or over areas where grating is suspected of needing to be changed out or repaired.
  • Ensuring all members onboard are aware of possible hazardous areas when arriving to the facility.
  • Adding signage where barricades are present noting why barricades are there and emphasizing any required fall protection.
  • Implementing stop work authority if there are any actions deemed unsafe or new hazards are found.
  • Reporting all incidents to the Operator’s Representative onboard and reporting those incidents to BSEE as outlined in CFR 250.188.
  • Reviewing Safety Alert 427 for recommendations regarding physical changes to grating and how it can affect its integrity.

Pin It on Pinterest

Share This