Most manufacturing operations are full of HART smart instruments, but often there are additional process variables from these devices that end up measured but not monitored because the field device only has one 4-20mA output.

If the distributed control system (DCS) or basic process control system (BPCS) is HART capable then these hosts could poll these smart HART instruments for this additional diagnostic and process data.

The problem is upgrading older input cards or legacy control systems to be HART smart compatible can be quite expensive.

When this occurs in an environment, it is possible to utilize the Class I Div 2/Zone 2 approved HIM HART Interface Module. The HIM has the ability to poll any HART smart device and turn its digital HART process measurement data into 4-20mA signals (up to three) for retransmission to any host.

Additionally, the HIM has optional alarm relays (up to two) that can end up used to alarm on anything from diagnostic bits, transmitter status to process variable limits.

Schneider Bold

The HIM is even multi-drop capable with an optional MODBUS RTU output that allows a remote MODBUS RTU host to poll it for the field transmitter’s HART variables; thus turning the HIM into an industrial HART-to-MODBUS gateway.

The following are key attributes for the HIM:

  • HART to Analog Conversion: Up to three AOs and two relay alarms
  • Local display
  • Class I Div 2/Zone 2 approval

Click here for more information on the HIM.

HIM and HART

HIM can poll any HART smart device and turn its digital HART process measurement data into 4-20mA signals (up to three) for retransmission to any host.
Source: Moore Industries

Pin It on Pinterest

Share This