A new poisonous gas detector is in development that can detect harmful chemical vapors via a sensor array on a piece of paper.

As most industry experts are aware, not all poisonous gases have a smell or a color, but this tiny grid of pastel- and candy-colored squares could effectively sniff out hazardous chemicals in the air.

These colorful square patterns in their inexpensive and durable paper-based sensor array can change color in the presence of poisonous gases, which will allow for quick and accurate measurements within minutes, researchers said.

Traditionally, electronic noses, or e-noses, are devices that detect harmful chemical vapors. But their electronic components can be pricey and aren’t practical for humid environments.

Meanwhile, optoelectronic noses may address these limitations by replacing the electronic components with dye molecules that change color when they react with certain chemicals.

Schneider Bold
New Optoelectronic Nose

To that end, Vijay Tak, a researcher at the VERTOX Laboratory, Defense Research and Development Establishment in India, and his colleagues created and tested a new optoelectronic nose design: An array of sensors that detect and measure deadly gases. Moreover, each sensor within the array is a tiny paper square containing microscopic silica particles coated with dyes that change color and intensity after interacting with specific molecules or ions.

As a proof-of-concept, Tak and the research team created the sensors by soaking silica microparticles in 36 different color-changing dye solutions.

After air drying them, they created a 12×3 array of color-changing sensors by placing the dried particles into a microwell plate, laying a piece of adhesive paper on top, and then flipping the plate so the dye-containing silica particles end up embossed onto the paper. Furthermore, to provide structural support for the array, a thin metal sheet is stuck to the sticky underside of the paper.

Poisonous gas sensor

The tiny squares in this colorful patchwork contain silica nanoparticles that can change color in the presence of toxic gases.
Source: Adapted from ACS Sensors


To test the array’s accuracy, the researchers exposed it to 12 poisonous gases at two concentrations each.

The team compared photos of the squares’ color and intensity before and after five minutes of gas exposure. This produced a pattern they could use to identify the type and concentration of gas present.

In repeated experiments, the color-changing sensors achieved 99 percent accuracy for identifying the type of chemical threat and 96 percent accuracy for measuring the concentration in the gas samples. Additionally, another demonstration confirmed the array’s accuracy was not affected by humidity.

Cost Effective Sensor

With an estimated fabrication cost of $.20 per array, the researchers said their designs could offer a cost-effective and customizable approach for environmental monitoring in real-world conditions.

Next, the team plans on developing a hand-held optoelectronic-nose prototype to test for hazardous chemicals outdoors.

Click here to view the paper entitled “Simple and Cost-Effective Fabrication of Embossed Colorimetric Sensor Array for an Optoelectronic Nose via Integration of a Self-Adhesive Paper and Mesoporous Colorimetric Silica Microparticles.”

Pin It on Pinterest

Share This