In order to ensure a safer environment after analyzing incident data that showed multiple cases of potential fires involving welding and buring operations, the past September, Performance-Based Risk Inspections (PBRIs) ended up conducted for 22 production and well operation sites in the Gulf of Mexico.

After an analysis of compliance and incident data since 2022 uncovered multiple high potential fires associated with welding and burning operations, it led the Bureau of Safety and Environmental Enforcement (BSEE) to conduct on-site targeted inspections of 13 production facilities and nine well operation facilities operated by 11 distinct operators. An evaluation of those inspections identified several critical issues requiring attention to ensure the safety and integrity of ongoing operations.

The PBRIs revealed instances where fire protection barriers (e.g., tarps, curtains, and blankets) were either inadequately placed or damaged, posing a risk to the safety of welding and burning operations.

In one incident, evidence suggests hot slag from a cutting torch pierced the underside blanket barrier of the living quarters building. The residual heat likely caused the wood subfloor to ignite.

The PBRIs identified the following concerns:

Schneider Bold
  • Workers were conducting hot work in areas located within 35 feet of equipment containing hydrocarbons.
  • There were inadequate housekeeping practices, with flammable sources like cardboard boxes found within 35 feet of hot work areas, posing an additional risk to safety.
  • No one properly identified tools for prevention, such as fire extinguishers and portable gas detectors, as being necessary.
  • Operations were taking place without an approved Safe Welding Plan, indicating a need for comprehensive safety measures and planning.
  • Offshore personnel were not following safe welding and hot work procedures. For example, one procedure requires the designated person-in-charge to personally verify the individual performing the burning had been trained to safely operate the oxygen/acetylene burning equipment. BSEE found at least one instance of this not having occurred.
  • Frequency of training for hot work and/or welding was inconsistent. BSEE was unable to determine from the Safe Welding
  • Plans or Safety and Environmental Management System (SEMS) Training Element if operators required individuals serving as welders to be trained and qualified to the appropriate industry standards and codes (e.g., American National Standards Institute, American Welding Society, American Society of Mechanical Engineers etc.), relative to the specific type of hot work tasks being performed.
  • Hot work permits and Job Safety Analyses (JSAs) listed the same person to perform fire watch and perform the hot work.

In one welding and burning operation on an offshore platform, fire spread to the living quarters following the removal of the heliport substructural frame using cutting torches.Source:BSEE

As a result of these inspections and understanding the results, BSEE recommends operators and their contractors consider doing the following:

  • Take all necessary precautions to control, remove, or otherwise correct any hazardous oil and gas accumulation or other safety, health, or fire hazard.
  • Inspect the rating, current condition, and placement of fire protection barriers to mitigate the potential risk caused by hot work, including personal protective equipment.
  • Review and mitigate any hazards associated with welding and burning operations, which warrant a heightened level of planning specific to the task’s risk.
  • Review training and competency requirements for hot work, ensuring these meet industry standards.
  • Ensure employees can understand and perform their jobs in a safe and environmentally sound manner.
  • Ensure all hot work operations end up inspected by the person in charge prior to commencement of work and ensuring adequate supervision and fire watches are in place throughout the duration of the work.
  • Adhere to all applicable planning and procedures for safe welding and hot work.
  • Require all operations and contract personnel attend and participate in pre-job JSA meetings and ensuring the supervisors of all phases of the work know and understand the complete scope of the job.
  • Ensure compliance with 30 CFR, Section 250.46, Safe and Workmanlike Operations.

Pin It on Pinterest

Share This