The management of helideck crews and passengers is a safety-critical operation that could lead to severe injuries or fatalities if not executed correctly.
The incident resulted from a combination of procedural lapses and behavioral failures that had the potential for catastrophic consequences. In this alarming near-miss event, a helicopter was stationed on the facility’s helideck and a crew member approached the aircraft from the rear, entering the rotor arc area before the rotor blades had come to a complete stop.
An offshore helideck assistant repeated the unsafe behavior by approaching the helicopter from the rear, entering the vicinity of the tail rotor, and positioning themselves within the main rotor’s danger zone immediately after the helicopter had landed on the facility’s helideck. These incidents occurred while the helicopter’s rotors were still in motion and before the pilot had signaled clearance for personnel to approach.
Upon recognizing the incursion, the helicopter’s air crew took immediate action by alerting the pilot, who was already in the process of engaging the rotor brakes.
Subsequently, the air crew invoked “Stop Work Authority” and took proactive steps to ensure the helideck crew fully understood the correct procedure for entering and exiting the helideck and safely approaching or departing from helicopters.
The incident underscores the importance of adhering to established safety protocols during helicopter operations on offshore facilities.
- BSEE recommends operators and their contractors consider the following:
- Do not enter the helideck until the helicopter blades have completely stopped, the anti-collision lights have been turned off, and/or a pilot gives the “thumbs-up” signal.
- Receive clear confirmation from the pilot, either through hand signals or radio communications, prior to approaching the helicopter or installing handrails.
- Ensure helideck crew members use the designated safe entry zones corresponding to the specific helicopter type during crew access and egress. These zones are for safety reasons, considering the unique characteristics of each aircraft.
- Make sure personnel are familiar with and understand helicopter loading and unloading policies and procedures to prevent incidents from occurring on the helideck.
- Ensure well planned safety critical operations and proper controls are in place to ensure flawless execution of the plan.
- Review policy guidelines in the company Health, Safety and Environment (HSE) manual and including area specific regulatory requirements and recommended practices.
- Critique operations for signs of weakness or noncompliance, and if you identify any, implement specific actions to correct them.
- Do not leave safety to chance by ensuring the development and implementation of a facility specific helicopter operations procedure.

After crew members walked dangerously close to moving helicopter rotors, BSEE created a graphic to show helicopter safe zones.
Source: BSEE

