A three-day pre-production inspection occurred last week on Vito, Shell’s new 40,000-ton semi-submersible platform, which is slated to begin operation soon in the Gulf of Mexico.

The job of the pre-production inspection team is to verify that all safety equipment, components, and production processes aboard the structure have been constructed as planned, meet industry standards, and comply with federal regulations.

Bureau of Safety and Environmental Enforcement’s (BSEE) on-site inspection is one of the steps required to clear the platform for sailing to its planned destination in the Gulf of Mexico, about 150 miles south of New Orleans, where it will be installed at a water depth of 4,000 feet.

The inspection was conducted by a team of 10 inspectors and engineers divided into two units, each simultaneously inspecting different areas of the facility for three consecutive days.

“These regulatory inspections are critical to help ensure that the platform meets all applicable safety rules, environmental compliance requirements, and relevant regulations and practices,” said Anthony Pizza, production operations section chief of the New Orleans District Office, Gulf of Mexico Regional Office. “Any discrepancies found will be addressed by Shell before operations begin.”

Schneider Bold

Vito will be Shell’s eighth operated deep-water floating production platform in the Gulf of Mexico.

It is expected online in the fourth quarter with a capacity of up to 100,000 barrels per day of oil fed through a subsea production system initially tied back to eight production wells, with deep in-well gas lift at 18,000 feet. It could be two to three years before gas lift may be used to improve oil recovery in the reservoir, but the equipment systems needed for it have been installed on the platform.

Deck space has been reserved for additional future needs, including a potential waterflood project that would require space for another two modules of processing equipment.

Lee Carter (left), a BSEE supervisory inspector and Zach Pisciotta, a BSEE production engineer trace schematics during a pre-production inspection of Shell’s Vito. BSEE personnel conducted a pre-production inspection of the Shell platform Vito at Kiewit shipyard in Ingleside, Texas.
Source: BSEE

Pin It on Pinterest

Share This